The maintenance of multi station cold heading machine is very necessary, but without it, it will fail. For the maintenance of multi station cold heading machine, multi station automatic cold heading machine refers to the cold heading machine method used to turn over various hexagon nuts and tap materials. The material is fed through the roller driver, and then the process of feeding, cutting, pressing, pressing and stamping is completed on one machine.

Features of hexagon bolt cold heading machine:

1. The driving device of main operating mechanism (cutting, die-cutting, feeding, etc.) adopts the shape of connecting rod.

2. We have realized the automatic production of bolts and screws from cutting, up roughing and trimming to one production line.

3. The introduction of the female die at the third station is applicable to the trimming process or up rough process, which is easy to replace and adjust.

4. A complete circular sleeve milling cutter is used, and the cutting end is very neat.

5. The pneumatic fixture can use the fixture to move the workpiece, and adjust the fixture and closing time of each fixture separately.

6. The processing station shall be placed horizontally.

General instructions for use of the chiller:

1. Before starting the machine, always check whether the equipment fasteners are locked and whether the safety protection devices are intact during the work. Please. This will be the cause of failure.

2. Protective devices must be added to prevent accidents caused by rupture.

3. After adjusting the equipment, first pull the flywheel to check whether each mechanism operates normally. After removing the tie rod to pull the vehicle, start the motor and check whether the machine works normally.

4. In case of failure, please immediately stop the cold news headlines of multiple sites, find out the causes and eliminate the hidden dangers.